![]() ![]() As it narrows - it's width approaches 0 and the nozzle won't fit. That may happen on the fingers of that model. Note how the missing layers line up with the red areas in the Cura view.Īnother reason for an incomplete slice would be that the Line Width you have set won't fit into the area being sliced. PrusaSlicer hated trying to slice it as well and the "The model won't be printable" message came up. So in my unprofessional opinion, that model be broke. Scaling the model to 250 tall makes the mesh 4 times as dense. The model is extremely dense at 1500mm tall. This report is from and it timed out (4 minute limit) trying to fix it. ![]() After simplifying the model I tried again. I tried to fix the file with Mesh Mixer and with MS 3D Builder and both crashed during the repair. Models with errors confuse a slicer and (in this case) Cura couldn't figure out what to do so it ignored those spots. There are a couple of reasons for areas to come out like that. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |